Question 6A511

When an auto-alarm bell rings continuously and cannot be stopped by the release button, it indicates a fault within the alarm system's control or silencing mechanism. * **A) Bell relay K-107 could be stuck, or there could be an open filament:** A stuck relay (K-107) directly explains the issue. If the relay that activates the bell is physically or electrically latched in the "on" position, the bell will continue to ring regardless of the release button. An "open filament" could refer to a failure in an older vacuum tube-based circuit, where a critical component in the alarm logic or release path has failed, leading to a persistent alarm state. * **B) The alarm bell relay circuit ground could be bad:** A poor ground connection in any part of the relay's control circuit can lead to erratic behavior. If the ground path for the relay coil or the release mechanism is compromised, the relay might not de-energize properly when the button is pressed, causing the bell to remain active. * **C) There could be failure or low line voltage:** Electronic and electromechanical systems rely on stable power. Low line voltage can cause relays to operate unreliably or fail to drop out. A power supply failure to the control circuitry could also disable the release mechanism or cause a "failsafe" alarm condition to persist. Since all these scenarios represent plausible technical failures that could lead to the described problem, "All of the above" is the correct answer.